Billet Bar Ends 7/8"

Billet Bar Ends — 7/8"

Machined in-house from solid 6061 aluminum bar stock, these bar ends are cut, not cast — every piece starts as a single billet and leaves the machine as a finished part. The result is a dense, substantial weight in your hand and a face that carries the Thirteen Motorcycles mark, recessed and engraved so it won't rub off.

They install in minutes with a stainless-hardware rubber bung: slide the assembly into the open end of your handlebar and tighten the stainless nut until the rubber bung presses firmly against the inside of the bar. Once seated, it holds by press fit — nothing else needed. No adhesives, no drilling, no guesswork. The extra mass at the ends also helps take the buzz out of your grips on longer rides.

Fits standard 7/8" (22mm) hollow handlebars. Sold as a matched pair with hardware included.

Details

• Machined from solid 6061 aluminum billet
• Fits 7/8" (22mm) hollow handlebars
• Stainless-hardware rubber bung — press fit, no glue, no drilling
• Engraved Thirteen Motorcycles 
• Adds weight to reduce grip vibration
• Made in small batches, sold as a pair (hardware included)

Installation

1. Remove any existing bar end or plug.
2. Insert the rubber bung assembly into the open end of the handlebar.
3. Tighten the stainless nut so the rubber bung presses firmly into the bar. Once seated it's a press fit — that's all it takes to hold.
4. Repeat on the other side. Done.